Kia Cee'd: Engine Control System / CVVT Oil Control Valve (OCV) Description and operation

Continuous Variable Valve Timing (CVVT) system advances or retards the valve timing of the intake and exhaust valve in accordance with the ECM control signal which is calculated by the engine speed and load.

By controlling CVVT, the valve over-lap or under-lap occurs, which makes better fuel economy and reduces exhaust gases (NOx, HC) and improves engine performance through reduction of pumping loss, internal EGR effect, improvement of combustion stability, improvement of volumetric efficiency, and increase of expansion work.

This system consist of

-the CVVT Oil Control Valve (OCV) which supplies the engine oil to the cam phaser or cuts the engine oil from the cam phaser in accordance with the ECM PWM (Pulse With Modulation) control signal,

- the CVVT Oil Temperature Sensor (OTS) which measures the engine oil temperature,

-and the Cam Phaser which varies the cam phase by using the hydraulic force of the engine oil.

The engine oil getting out of the CVVT oil control valve varies the cam phase in the direction (Intake Advance/Exhaust Retard) or opposite direction (Intake Retard/Exhaust Advance) of the engine rotation by rotating the rotor connected with the camshaft inside the cam phaser.

Purge Control Solenoid Valve (PCSV) Repair procedures

Inspection 1. Turn the ignition switch OFF. 2. Disconnect the PCSV connector. 3. Measure resistance betwe ...

CVVT Oil Control Valve (OCV) Specifications

Specification   Item Specification Coil Resistance (Ω) 6.9 ~ 7.9 [20°C(68°F)] ...

Other information:

Kia Cee'd JD Service Manual: TJ Joint Components and components location
Components [LH]   1. BJ assembly 2. BJ circlip 3. BJ boot band 4. BJ boot 5. Shaft 6. TJ boot band 7. TJ boot 8. Spider assembly 9. Retainer ring 10. TJ housing 11. Housing circlip ...

Kia Cee'd JD Service Manual: Input Speed Sensor 1 Repair procedures
Inspection Refer to DTC code "P2765, P2766" Input Shaft Speed Sensor. Removal 1. Turn off the ignition switch and then disconnect the battery (-) cable. 2. Remove the under cover. 3. ...