Kia Cee'd: Blower / Blower Unit Repair procedures

Kia Cee'd JD Service Manual / Heating,Ventilation, Air Conditioning / Blower / Blower Unit Repair procedures

Replacement

1.	Disconnect the negative (-) battery terminal.

2.	Remove the heater & blower assembly. (Refer to Heater - "Heater Unit")

Separate the blower unit from the heater unit after loosening the screws.

•	Make sure that there is no air leaking out of the blower and duct joints.

4.	Install in the reverse order of removal.

Blower Unit Components and components location

Component Location Components 1. Intake Seal 2. Intake Upper Case 3. Intake Actuator 4. Climate control air filter 5. Climate control ...

Blower Motor Repair procedures

Inspection 1. Connect the battery voltage and check the blower motor rotation. 2. If the blower motor does not operate well, ...

Other information:

Kia Cee'd JD Owners Manual: Tire Pressure Monitoring System (TPMS) indicator
Low tire pressure telltale/ TPMS malfunction indicator The low tire pressure telltale comes on for 3 seconds after the ignition switch is turned to the ON position. The low tire pressure and position telltales illuminates when one or more of your tires is significantly underinflated. ...

Kia Cee'd JD Service Manual: Rear Wheel Speed Sensor Repair procedures
Removal 1. Remove the rear wheel and tire. Tightening torque: 88.3 ~ 107.9 N.m (9.0 ~ 11.0 kgf.m, 65.1 ~ 79.6 lb-ft) 2. Remove the rear wheel speed sensor mounting bolt (A). ...