| Troubleshooting |
|
Symptom |
Suspect Area |
Remedy (Refer to page) |
|
Water leaks from panoramaroof |
Deteriorated roof lid weatherstrip |
Replace |
|
Excessive roof lid-to-body clearance and improperly fitted weatherstrip
|
Adjust |
|
|
Wind noise around panoramaroof |
Loose or deformed deflector, gaps in body work |
Retighten adjust or replace |
|
Noise heard when opening/ closing panoramaroof |
Foreign particles lodged in guide rail |
Check drive cable and guide rails for foreign particles |
|
Loose guide rails and lid |
Retighten |
|
|
Motor runs but sunroof does not move or moves only partially |
Foreign particles lodged in guide rail |
Adjust or replace |
|
Incorrect engagement of motor pinion with drive cable |
||
|
Decrease in motor`s clutch slipping force |
||
|
Increased sunroof sliding resistance or interference of sunroof with drive
cables, weatherstrip, etc. due tomal adjustment of sunroof |
||
|
Noise in motor (clutch slipping noise from motor when sunroof is fully opened
or closed is not an unusual noise |
Incorrect engagement of motor pinion with drive cable |
Check pinion installation and |
|
Re-tighten motor |
||
|
Worn out or damaged motor pinion bearing |
Replace motor assembly |
|
|
Worn out or deformed drive cable |
Replace |
|
|
Door glass fails to operate up and down |
Incorrect window glass installation |
Adjust position |
|
Damaged or faulty regulator arm or regulator |
Correct or replace |
|
|
Door does not open or close completely |
Incorrect door installation |
Adjust position |
|
Defective door check assembly |
Correct or replace |
|
|
Door hinge requires grease |
Apply grease |
|
|
Hood does not open or close completely |
Striker and latch not properly aligned |
Adjust |
|
Incorrectly installed hood |
Adjust |
|
|
Incorrect hood bumper height |
Adjust |
|
|
Water leak through windshield end rear window |
Defective seal |
Fill with sealant |
|
Defective flange |
Correct |
Special service tools
FenderFord Escape 2020-2026 Owners Manual: Declaration of Conformity
Radio Frequency Statement
WARNING: Changes or
modifications not expressively approved
by the party responsible for compliance
could void the user's authority to operate
the equipment. The term "IC:" before the
radio certification number only signifies
that Industry Canada technical
specifica ...
Kia Cee'd JD Owners Manual: Manual heating and air conditioning
The heating and cooling system can be
controlled manually by pressing buttons
or turning knob(s) other than the AUTO
button. In this case, the system works
sequentially according to the order of
buttons or knob(s) selected.
1. Start the engine.
2. Set the mode to the desired position.
...