Kia Cee'd: General Information / Special service tools

Kia Cee'd JD Service Manual / Body (Interior and Exterior) / General Information / Special service tools

Special Service Tools

Tool (Number and name)	Illustration	Use
09861-31100 Sealany cut-out tool		Cutting windshield sealant (use with 09861-31200)
09861-31200 Sealant cutting blade		Cutting windshield sealant (use with 09861-31100)
09861-31000 Windshield molding remover		Windshield molding removal
09880-4F000 Hog ring clip installer		Hog ring clip installation
09816-2P100 Power silent cutting tool		Tool box for removing panoramaroof
09816-2P110 Air power tool		Air tool for installing blade
09816-2P121 Cutter-1		Blade for removing the front and side area of panoramaroof (This blade has a inclination to push upward.)
09816-2P122 Cutter-2		Blade for removing the front and side area of panoramaroof (This blade has a inclination to push downward.)
09816-2P123 Cutter-3		Blade for removing the front and side area of panoramaroof (This blade has a inclination to push downward.)
09816-2P124 Cutter-4		Blade for removing the front and side area of panoramaroof (This blade has a inclination to push downward.)
09816-2P127 Cutter-5		Blade for removing the rear area of panoramaroof
09816-2P130 Cutter-10		Blade for removing the edge area of panoramaroof

Specifications

Specifications Items Specification Hood Type Rear hinged, front opening type Front Door ...

Troubleshooting

Troubleshooting Symptom Suspect Area Remedy (Refer to page) Water leaks from panoramaroof Deteriorated roo ...

Other information:

Kia Cee'd JD Owners Manual: Outside rearview mirror
Be sure to adjust mirror angles before driving. Your vehicle is equipped with both lefthand and right-hand outside rearview mirrors. The mirrors can be adjusted remotely with the remote switch. The mirror heads can be folded back to prevent damage during an automatic car wash or when ...

Kia Cee'd JD Service Manual: Height Sensor Repair procedures
Removal 1. Disconnect the negative (-) battery terminal. 2. Disconnect the head lamp height sensor connector. 3. Remove the assist arm (A). 4. Remove the head lamp auto level ...