Kia Cee'd: Heater / Temperature Control Actuator Description and operation

The heater unit includes mode control actuator and temperature control actuator.

The temperature control actuator is located at the heater unit. It regulates the temperature by the procedure as follows. Signal from the control unit adjusts the position of the temperature door by operating temperature switch and then temperature will be regulated by the hot/cold air ratio decided by the position of tne temperature door.

Evaporator Core Repair procedures

Replacement 1. Disconnect the negative (-) battery terminal. 2. Remove the heater & blower assembly. (Refer to Heater - &q ...

Temperature Control Actuator Repair procedures

Inspection 1. Turn the ignition switch OFF. 2. Disconnect the temperature control actuator connector. 3. ...

Other information:

Kia Cee'd JD Owners Manual: Fuel gauge
The fuel gauge indicates the approximate amount of fuel remaining in the fuel tank. ✽ NOTICE The fuel tank capacity is given in chapter 8. The fuel gauge is supplemented by a low fuel warning light, which will illuminate when the fuel tank is nearly empty. On inclines or ...

Kia Cee'd JD Service Manual: Blower Resistor (Manual) Repair procedures
Inspection 1. Measure the resistance between the terminals. 2. If the measured resistance is not within specification, the blower resistor must be replaced. (After removing the resistor.) Replacement ...