Kia Cee'd: Blower / Blower Resistor (Manual) Repair procedures

Kia Cee'd JD Service Manual / Heating,Ventilation, Air Conditioning / Blower / Blower Resistor (Manual) Repair procedures

Inspection

1.	Measure the resistance between the terminals.

2.	If the measured resistance is not within specification, the blower resistor must be replaced. (After removing the resistor.)

Replacement

1.	Disconnect the negative (-) battery terminal.

2.	Disconnect the connector (A) and then remove the blower resistor (B) after loosening the mounting screws.

3.	Install in the reverse order of removal.

Blower Motor Repair procedures

Inspection 1. Connect the battery voltage and check the blower motor rotation. 2. If the blower motor does not operate well, ...

Power Mosfet (DATC) Repair procedures

Inspection 1. Turn the ignition switch ON. 2. Manually operate the control switch and measure the voltage of the blower motor. ...

Other information:

Kia Cee'd JD Service Manual: ISG (Idle Stop & Go) Description and operation
Description Idle Stop & Go (ISG) system switches off the ignition when vehicle is stopped, and then restarts the ignition and starts the vehicle when accelerator is pushed. It temporarily stops the engine while waiting for signal or idling to improve fuel efficiency and ...

Kia Cee'd JD Service Manual: Components and components location
Components 1. LDWS ON/OFF switch 2. Instrument cluster 3. LDWS unit ...