Kia Cee'd: Crash Pad / Steering Column Shroud Panel Repair procedures

Kia Cee'd JD Service Manual / Body (Interior and Exterior) / Crash Pad / Steering Column Shroud Panel Repair procedures

Replacement
  
When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.
Put on gloves to protect your hands.
  
Take care not to scratch the body surface.
1.
Remove the crash pad lower panel.
(Refer to Crash Pad - "Crash Pad Lower Panel")
2.
After loosening the mounting screws, then remove the steering column lower shroud panel (A).

3.
Using a screwdriver or remover, remove the steering column upper shroud panel (A).

4.
Install in the reverse order of removal.
  
Replace any damaged clips.
Steering Column Shroud Panel Components and components location
Component Location   1. Steering column lower shroud panel 2. Steering column upper shroud panel ...

Crash Pad Side Cover Components and components location
Component Location [LH]   1. Crash pad side cover [LH] [RH]   1. Crash pad side cover [RH] ...

Other information:

Kia Cee'd JD Owners Manual: Jack label
■ Type A ■ Type B ■ Type C 1. Model Name 2. Maximum allowable load 3. When using the jack, set your parking brake. 4. When using the jack, stop the engine. 5. Do not get under a vehicle that is supported by a jack. 6. The designated locations under the frame 7. When supp ...

Kia Cee'd JD Owners Manual: Installing a child restraint system by lap/shoulder belt
To install a child restraint system on the outboard or center rear seats, do the following: 1. Place the child restraint system in the seat and route the lap/shoulder belt around or through the restraint, following the restraint manufacturer’s instructions. Be sure the seat belt webbi ...

© 2017-2020 www.kceed.com