Kia Cee'd: Winter driving / Snowy or Icy conditions
To drive your vehicle in deep snow, it may be necessary to use snow tires or to install tire chains on your tires. If snow tires are needed, it is necessary to select tires equivalent in size and type of the original equipment tires. Failure to do so may adversely affect the safety and handling of your vehicle. Furthermore, speeding, rapid acceleration, sudden brake applications, and sharp turns are potentially very hazardous practices.
During deceleration, use engine braking to the fullest extent. Sudden brake applications on snowy or icy roads may cause skids to occur. You need to keep sufficient distance between the vehicle in operation in front and your vehicle. Also, apply the brake gently. It should be noted that installing tire chains on the tire will provide a greater driving force, but will not prevent side skids.
✽ NOTICE
Tire chains are not legal in all countries. Check the country laws before fitting tire chains.
Winter driving
Severe weather conditions in the winter
result in greater wear and other problems.
To minimize the problems of winter
driving, you should follow these suggestions: ...
Snow tires
If you mount snow tires on your vehicle,
make sure they are radial tires of the
same size and load range as the original
tires. Mount snow tires on all four wheels
to balance your vehicle’s ...
Other information:
Kia Cee'd JD Owners Manual: Ending voice recognition
While Voice Recognition is operating
Press and hold the key on the
steering remote controller.
✽ NOTICE
While using voice command,
pressing a steering wheel remote
control or a different key will end
voice command.
When the system is waiting for a
voice command, say “cance ...
: Inspecting the Wheel Valve Stems. Tire Rotation
Inspecting the Wheel Valve Stems
Check the valve stems for holes,
cracks, or cuts that could permit
air leakage.
Tire Rotation
WARNING: If the tire label
shows different tire pressures for
the front and rear tires and the
vehicle has a tire pressure
monitoring system, then you
need to update ...
