Kia Cee'd: Dual Clutch Transmission Control System / Shift Cable Repair procedures

Kia Cee'd JD Service Manual / Dual Clutch Transmission(DCT) System / Dual Clutch Transmission Control System / Shift Cable Repair procedures

Removal

1.	Remove the floor console assembly. (Refer to Body - "Floor Console")

2.	Remove the air duct.

3.	Remove the control cable (A).

Remove the retainer (A) and nut (B).

Tightening torque:

11.8 ~ 14.7 N.m (1.2 ~1.5 kgf.m, 8.7 ~ 10.8 lb-ft)

Remove the nut (A) from the manual control lever.

Tightening torque:

(A) : 9.8 ~ 14.7 N.m (1.0 ~1.4 kgf.m, 7.2 ~ 10.8 lb-ft)

6.	Remove the cable (C) from the cable bracket (B) on the Dual Clutch Transmission (DCT).

7.	Remove the shift cable by pulling it toward the interior.

Installation

Install in the reverse order of removal.

•	Install the cable after placing the shift lever and the transmission manual control lever in the N position.

•	Adjust the control cable.

Adjustment

1.	Place the shift lever in the interior, and the transmission manual control lever, to the N position.

2.	Connect the shift lever (B) in the interior with the shift cable (A).

3.	Lightly push the shift cable towards "F" to tighten the cable.

Tighten the nut (A) to the specified torque.

Tightening torque:

9.8 ~ 14.7 N.m (1.0 ~1.4 kgf.m, 7.2 ~ 10.8 lb-ft)

Shift Cable Components and components location

Components 1. Shift lever assembly 2. Shift cable assembly 3. Retainer 4. Bolt 5. Nut 6. Manual control lever 7. Knob ...

Gear Actuator Components and components location

Component Location 1. Gear actuator 2. Dual Clutch Transmission (DCT) ...

Other information:

: Navigation Voice Commands (If Equipped)
Setting a Destination You can use any of the following commands to set a destination or find a point of interest. ___ is a dynamic listing, meaning that for navigation voice commands it can be a POI category or a major brand name, where major brand name is a chain with more than 20 locations Y ...

Kia Cee'd JD Service Manual: Repair procedures
Replacement • When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage. ...