Kia Cee'd: Panoramaroof / Roll Blind Repair procedures

Replacement
[Removal]
1.
Remove the roof trim.
(Refer to Roof Trim - "Roof Trim Assembly")
2.
Open the movable glass fully.
3.
Loosen the roll blind lower bracket (A) mounting screws.
  
Do not damage the screws.

4.
Remove the roll blind (A) by pulling it at a right angle.
  
When you removing it, be care of that an edge (B) is dashed against the frame of vehicle because the roll blind tension loosen.

[Installation]
1.
Installation is the roll blind (A).
  
When you install it, be care of that an edge (B) is dashed against the frame of vehicle because the roll blind tension loosen.

2.
Install the screws to the roll blind lower bracket (A).
  
Do not damage the screws.

3.
Install the roof trim.
Panoramaroof Deflector Repair procedures
Replacement 1. Open the movable glass fully. 2. Loosen the panoramaroof deflector side's mounting screw (A). ...

Panoramaroof Assembly Components and components location
Component Location   1. Panoramaroof assembly ...

Other information:

Kia Cee'd JD Service Manual: Input Speed Sensor 2 Repair procedures
Inspection Refer to DTC code "P2765, P2766" Input Shaft Speed Sensor. Removal 1. Turn off the ignition switch and then disconnect the battery (-) cable. 2. Remove the under cover. 3. ...

Kia Cee'd JD Service Manual: Blower Unit Components and components location
Component Location Components   1. Intake Seal 2. Intake Upper Case 3. Intake Actuator 4. Climate control air filter 5. Climate control air filter Cover 6. Intake Door 7. Intake Lower Case 8. NVH Pad 9. Blower Upper ...

© 2017-2026 www.kceed.com