Kia Cee'd: Crankcase Emission Control System / Repair procedures

Inspection
1.
After disconnecting the vapor hose from the PCV valve, remove the PCV valve.
2.
Reconnect the PCV valve to the vapor hose.
3.
Run the engine at idle, then put a finger over the open end of the PCV valve and make sure that intake manifold vacuum can be felt.
  
The plunger inside the PCV valve will move back and forth at vacuum.

4.
If the vacuum is not felt inspect PCV operation, if operating correctly clean or replace the vapor hose.
Schematic diagrams
Schematic Diagram ...

Positive Crankcase Ventilation (PCV) Valve Description and operation
Operation Principle ...

Other information:

Kia Cee'd JD Service Manual: Receiver-Drier Repair procedures
Replacement 1. Remove the condenser. 2. Remove the cap (B) on the bottom of the condenser with a L wrench (A). Tightening torque : 9.8 ~ 14.7 N.m (1.0 ~ 1.5 kgf.m, 7.2 ~ 10.8 lb-ft) ...

: Engine Oil Capacity and Specification - 1.5L EcoBoost™
Use oil that meets the defined specification and viscosity grade. If you do not use oil that meets the defined specification and viscosity grade, it could result in: Component damage that your vehicle warranty does not cover. Longer engine cranking periods. Increased emission levels. Reduc ...

© 2017-2026 www.kceed.com