Kia Cee'd: Electro chromic Inside Rear View Mirror / Repair procedures

Kia Cee'd JD Service Manual / Body Electrical System / Electro chromic Inside Rear View Mirror / Repair procedures

Inspection
Check it by the procedure below to see if the function of the ECM is normal.
1.
Turn the ignition key to the "ON" position.
2.
Cover the front sensor to stop functioning.
3.
Shine a light at the rear sensor.
4.
The ECM should be darkened as soon as the rear sensor detects the light.
  
If this test is performed in daytime, the ECM may be darkened as soon as the front sensor is covered.
5.
When the reverse gear is engaged, the ECM should not be darkened.
6.
When heading lights to both the front and rear sensors, the ECM should not be darkened.
Removal
1.
Disconnect the negative (-) battery terminal.
2.
Remove the mirror wiring cover (B) and disconnect the connector (A).

3.
Remove the mounting screw (A).
4.
Slide the inside rear view mirror rearward to remove the inside rear view mirror assembly (B).

  
Take care not to damage the mounting bracket during removal.
Installation
1.
Install the mirror assembly.
2.
Install the mirror wiring cover and connector.
  
–
Make sure the connector is plugged in properly.
Description and operation
Description The ECM (Electro Chromatic inside rear view Mirror) is for dimming the reflecting light from a vehicle behind at night, Preventing glare from the light. The forward f ...

Hands Free System
...

Other information:

: High Voltage Battery Vehicle Precautions - Hybrid Electric Vehicle (HEV)
In the event of damage or fire involving an electric vehicle or hybrid-electric vehicle: Assume the high-voltage battery and associated components are energized and fully charged. Exposed electrical components, wires and high-voltage batteries present potential high-voltage shock hazards ...

Kia Cee'd JD Service Manual: Input Speed Sensor 2 Repair procedures
Inspection Refer to DTC code "P2765, P2766" Input Shaft Speed Sensor. Removal 1. Turn off the ignition switch and then disconnect the battery (-) cable. 2. Remove the under cover. 3. ...

© 2017-2026 www.kceed.com