Kia Cee'd: Panoramaroof / Repair procedures

Adjustment
Inspect Glass Alignment
1.
Check for abnormal noise or bending during operation.
2.
With the sunroof fully closed, check for water leakage.
3.
The roof panel (B) should be even with the movable glass (A) weatherstrip, to within the standard value "E" all the way around. If not, make the following adjustment.
Tightening torque :
Standard value "E" [mm(in.)]
(1) Front edge : 1.2 mm (0.0472 in.)
(2) Rear edge : 1.0 mm (0.0394 in.)

4.
If the position is not as specified, lightly loosen the glass adjusting screws (A) to adjust the glass height and tighten it.
  
Do not damage the screws.
[Front]

[Rear]

Operating The Panoramaroof Emergency Handle
1.
Use the panoramaroof emergency handle to close and open the panoramaroof manually for the following case only.
To close the panoramaroof before driving a vehicle in a rainy day or on the highway if the panoramaroof can not be closed due to failure of the panoramaroof motor or controller.
2.
Operating method.
Remove the roof trim.
Push the emergency handle up into the hexagonal drive of the panoramaroof motor. You must push hard enough to disengage the motor clutch; otherwise the emergency handle will slip due to incomplete fit in the motor.
Carefully turn the emergency handle clockwise to close the panoramaroof.
After closing the sunroof, wiggle the handle back and forth as you remove the tool from the motor, to ensure the motor clutch reengages.
A 5mm hex socket may be used in place of the emergency handle, with a” Speeder” type handle.
  
Do not use power tools to operate the panoramaroof.
Damaged to the components may occur.

Components and components location
Components (1)   1. Roof side molding 2. Movable glass 3. Panoramaroof frame assembly 4. Wind deflector 5. Impact cross memeer upper assembly 6. ...

Movable Glass Repair procedures
Replacement 1. Open the movable glass fully. 2. Loosen the movable glass mounting screws (A). ...

Other information:

Kia Cee'd JD Service Manual: Description and operation
Description Clutch switch is connected to clutch pedal and transmits clutch operating state to ECM. When clutch pedal is depressed during driving, engine load changes from loaded to none loaded condition. However, ECM regards vehicle to be loaded becuase VSS signal is s ...

Kia Cee'd JD Owners Manual: Parking assist system
■ Front ■ Rear (3 Door) ■ Rear (5 Door) ■ Rear (Wagon) The parking assist system assists the driver during movement of the vehicle by chiming or displaying the area an obstacle is detected on the instrument cluster if any object is sensed within the distance of 100 cm (39.4 ...

© 2017-2026 www.kceed.com