Kia Cee'd: Steering wheel / Repair procedures

Replacement
1.
Disconnect the battery negative cable from the battery and then wait for at least 30 seconds.
2.
Turn the steering wheel so that the front wheels can face straight ahead.
3.
Remove the airbag module.
4.
Disconnect the connector & lock nut (A) and then remove the steering wheel (B) by using special service tools (09561-11001).
Tightening torque :
39.2 ~ 44.1 N.m(4.0 ~ 4.5 kgf.m, 28.9 ~ 32.5 lb-ft)

  
Do not hammer on the steering wheel to remove it; it may damage the steering column.
5.
Installation is the reverse of the removal.
Disaseembly
1.
Loosen the screw (A-3ea) and then remove the lower cover (B) from the steering wheel body.
Tightening torque :
7.8 ~ 11.8 N.m(0.8 ~ 1.2 kgf.m, 5.8 ~ 8.7 lb-ft)

2.
Remove the garnish (A).

3.
Remove the wiring (A).

4.
Loosen the screw (A-6ea) and then remote control switch assembly (B) from the garnish.
Tightening torque :
7.8 ~ 11.8 N.m(0.8 ~ 1.2 kgf.m, 5.8 ~ 8.7 lb-ft)

5.
Installation is the reverse of the removal.
Components and components location
Component   1. Airbag module 2. Remote control assembly 3. Garnish 4. Steering wheel 5. Wiring 6. Lower cover ...

Heated Steering wheel Description and operation
Description "The heated steering wheel features an internal heating element that maintains the steering wheel temperature to a consistent level during cold seasons. A heater ...

Other information:

Kia Cee'd JD Service Manual: Repair procedures
Component Replacement After Deployment    Before doing any SRS repairs, use the GDS to check for DTCs. Refer to the Diagnostic Trouble Code list for repairing of the related DTCs. When ...

Kia Cee'd JD Service Manual: Heater & A/C Control Unit (DATC) Repair procedures
Self Diagnosis 1. Self-diagnosis process 2. How to read self-diagnostic code After the display the panel blinks three times every 0.5 second, the corresponding fault code blinks on the setup temperature display pan ...

© 2017-2020 www.kceed.com