Kia Cee'd: Rear Seat Belt / Rear Seat Belt Buckle Repair procedures

Kia Cee'd JD Service Manual / Body (Interior and Exterior) / Rear Seat Belt / Rear Seat Belt Buckle Repair procedures

Replacement

1.	Remove the rear seat cushion assembly. (Refer to Rear Seat - "Rear Seat Assembly")

2.	Disconnect the rear seat belt buckle connector (B).

Loosen the mounting bolt, and then remove the rear seat belt buckle (A).

[LH]

Tightening torque :

39.2 ~ 53.9 N.m (4.0 ~ 5.5 kgf.m, 28.9 ~ 39.8 lb-ft)

[RH]

Tightening torque :

39.2 ~ 53.9 N.m (4.0 ~ 5.5 kgf.m, 28.9 ~ 39.8 lb-ft)

Install in the reverse order of removal.

•	Replace any damaged clips.

•	Make sure the connector is plugged in properly.

Rear Seat Belt Buckle Components and components location

Component Location 1. Rear seat belt buckle [LH] 2. Rear seat belt buckle [RH] ...

Body Electrical System

...

Other information:

Kia Cee'd JD Owners Manual: To install the barrier net
1. Open the cover (if equipped) for the holder position (1) or (2) you want to install. 2. Compress the one side net upper shaft to length direction before insert the net upper shaft into the large hole (3) and then secure by sliding into the small hole (4). 3. Hang the net strap ...

Kia Cee'd JD Service Manual: Neutral Switch Description and operation
Description • Signal of neutral switch is transmitted to the ECM in the neutral state. • This signal is blocked when gear changed. • When the signal is blocked, The ECM controls the fuel injection ...