Kia Cee'd: Rear Seat / Rear Seat Assembly Repair procedures

Kia Cee'd JD Service Manual / Body (Interior and Exterior) / Rear Seat / Rear Seat Assembly Repair procedures

Replacement
1.
After loosening the mounting bolts and then push it up and remove the rear seat cushion assembly (A).
Tightening torque :
16.7 ~ 25.5 N.m (1.7 ~ 2.6 kgf.m, 12.3 ~ 18.8 lb-ft)
[5Door, Waggon]

[3Door]

2.
Loosen the rear center seat belt buckle (A) mounting bolt.
Tightening torque :
39.2 ~ 53.9 N.m (4.0 ~ 5.5 kgf.m, 28.9 ~ 39.8 lb-ft)

3.
Remove the rear seat back center hinge bracket cover (A).

4.
Loosen the rear seat back mounting bolt (A).
Tightening torque :
16.7 ~ 25.5 N.m (1.7 ~ 2.6 kgf.m, 12.3 ~ 18.8 lb-ft)

5.
Pull out the rear seat center mounting bracket (A).
6.
Remove the rear seat back assembly (B).

7.
Install in the reverse order of removal.
Rear Seat Assembly Components and components location
Component Location   1. Rear seat cushion assembly 2. Rear seat back assembly ...

Rear Seat Back Cover Components and components location
Component Location   1. Rear seat back cover [LH] 2. Rear seat back cover [RH] ...

Other information:

Kia Cee'd JD Service Manual: Troubleshooting
Failure Diagnosis 1. In principle, ESP and TCS controls are prohibited in case of ABS failure. 2. When ESP or TCS fails, only the failed system control is prohibited. 3. However, when the solenoid va ...

Kia Cee'd JD Service Manual: Description and operation
Description Clutch switch is connected to clutch pedal and transmits clutch operating state to ECM. When clutch pedal is depressed during driving, engine load changes from loaded to none loaded condition. However, ECM regards vehicle to be loaded becuase VSS signal is s ...

© 2017-2020 www.kceed.com