Kia Cee'd: Cylinder Block / Rear Oil Seal Repair procedures

Kia Cee'd JD Service Manual / Engine Mechanical System / Cylinder Block / Rear Oil Seal Repair procedures

Removal

1.	Remove the transaxle assembly. (Refer to Manual Transaxle System - "Manual Transaxle")

2.	MT : Remove the flywheel. (Refet to Cylinder Block - "FlyWheel")

3.	AT : Remove the drive plate. (Refet to Cylinder Block - "Drive Plate")

4.	Remove the rear oil seal(A).

Installation

Install the rear oil seal.

(1)	Apply engine oil to a new oil seal lip.

(2)	Using the SST(09231-H1100, 09231-2B200) and a hammer, tap in the oil seal until its surface is flush with the rear oil seal retainer edge.

2.	MT : Install the flywheel. (Refet to Cylinder Block - "FlyWheel")

3.	AT : Install the drive plate. (Refet to Cylinder Block - "Drive Plate")

4.	Install the transaxle assembly. (Refer to Manual Transaxle System - "Manual Transaxle")

Rear Oil Seal Components and components location

Components 1. Rear oil seal ...

Cylinder Block Components and components location

Components 1. Cylinder block 2. Ladder frame 3. Crank shaft 4. Crank shaft upper bearing 5. Crank shaft lower bearin ...

Other information:

Kia Cee'd JD Owners Manual: Door lock/unlock features
Impact sensing door unlock system All doors will automatically unlock when an impact causes the air bags to deploy. Speed sensing door lock system (if equipped) All doors will automatically lock after the vehicle speed exceeds 15 km/h. Engine off door unlock system (if equipped) All doo ...

Kia Cee'd JD Service Manual: Audio Remote Control Repair procedures
Inspection Type A 1. Check the audio remote control switch (A) for resistance between terminals in each switch position. [Audio] Switch Connector terminal Res ...