Kia Cee'd: Rear Bumper / Rear Bumper Cover Repair procedures

Kia Cee'd JD Service Manual / Body (Interior and Exterior) / Rear Bumper / Rear Bumper Cover Repair procedures

Replacement

•	Put on gloves to protect your hands.

•	Use a plastic panel removal tool to remove interior trim pieces to protect from marring the surface.

•	Take care not to bend or scratch the trim and panels.

1.	After loosening the mounting screws, then remove the rear combination lamp (A). [5Door] [3Door]

2.	Disconnect the rear combination lamp connector (A).

3.	After loosening the rear bumper side's mounting screws, then disconnect the side's.

4.	Loosen the rear bumper lower mounting clips.

5.	Loosen the rear bumper lower mounting bolts.

6.	Loosen the rear bumper upper mounting screw and clip.

7.	Remove the rear bumper cover (A).

8.	Disconnect the rear bumper main connector (A).

Install in the reverse order of removal.

•	Replace any damaged clips.

•	Make sure the connector is plugged in properly.

Rear Bumper Cover Components and components location

Component Location 1. Rear bumper cover ...

Rear Bumper beam Assembly Components and components location

Component Location 1. Rear bumper beam assembly ...

Other information:

Kia Cee'd JD Service Manual: Power Mosfet (DATC) Repair procedures
Inspection 1. Turn the ignition switch ON. 2. Manually operate the control switch and measure the voltage of the blower motor. 3. Select the control switch to raise the voltage until high speed. ...

Kia Cee'd JD Owners Manual: Vehicle weight
This chapter will guide you in the proper loading of your vehicle and/or trailer, to keep your loaded vehicle weight within its design rating capability, with or without a trailer. Properly loading your vehicle will provide maximum return of the vehicle design performance. Before loading ...