Kia Cee'd: Front light replacement / Position light (3, bulb type)
Follow the steps 1 to 9 from the previous page.
10. Pull out the socket from the assembly.
11. Pull the bulb out of the socket.
12. Insert a new bulb into the socket.
13. Install the socket into the assembly.
14. Install the headlight bulb cover by turning it clockwise.
Follow the steps 1 to 7 from the previous
chapter.
8. Remove the cover by turning it counterclockwise.
9. Disconnect the headlight bulb socketconnector.
10. Unsnap the headlight bulb retaining
wire by depressing the end and pushing
it upward.
1 ...
Headlight (Low, Non-HID Type)
Follow the steps 1 to 7 from the previous
page.
8. Remove the cover by turning it counterclockwise.
9. Remove the socket from the assembly
by turning the socket counterclockwise
until the ta ...
Other information:
Kia Cee'd JD Service Manual: IMS Power Seat Control Repair procedures
Inspection
1.
Disconnect the IMS control switch connector.
2.
With the power IMS control switch in each position, make sure that continuity
exists between the terminals below. If continuity is not as specified,
replace ...
: Blind Spot Information System Requirements. Switching Blind Spot Information System On and Off
Blind Spot Information System Requirements
Blind spot information system turns on
when all the following occur:
You start your vehicle.
You shift into drive (D).
The vehicle speed is greater than
6 mph (10 km/h).
Switching Blind Spot Information System On and Off
To switch blind spot informa ...
