Kia Cee'd: Voice Recognition / Phonebook List Best Practice

1) Do not store single-name entries (e.g., “Bob”, “Mom”, “Kim”, etc.). Instead, always use full names (including first and last names) for phonebook (e.g., use “Jacob Stevenson” instead of “Dad”).

2) Do not use abbreviations (i.e., use “Lieutenant” instead of “Lt.” or “Sergeant” instead of “Sgt.”).

3) Do not use acronyms (i.e., use “County Finance Department” instead of “CFD”).

4) Do not use special characters (e.g., “@”, “hyphen -”, “asterisk *”, ampersand &”).

5) If a name is not recognized from the phonebook, change it to a more descriptive name (e.g., use “Grandpa Joseph” instead of “Pa Joe”).

Skipping Prompt Messages

While prompt message is being stated Shortly press the key on the steering remote controller.

The prompt message is immediately ended and the beep tone will sound. After the “beep”, say the voice command.

Re-starting Voice Recognition

While system waits for a command Shortly press the key on the steering remote controller.

The command wait state is immediately ended and the beep ton will sound. After the “beep”, say the voice command.

Using Voice Recognition
Starting Voice Recognition Shortly press the key on the steering wheel Say a command. If voice recognition is in [Normal Mode], then the system will say “Please say a command. Beep~” ...

Ending voice recognition
While Voice Recognition is operating Press and hold the key on the steering remote controller. ✽ NOTICE While using voice command, pressing a steering wheel remote control or a differ ...

Other information:

Kia Cee'd JD Owners Manual: Non-operating condition
Never use the Smart Parking Assist System in the below conditions. Curved parking space Inclined roads A vehicle loaded with longer or wider cargo compared to the vehicle Diagonal parking space Parking space with trash, grass or barriers Heavy snow or rain A pole close to the pa ...

Kia Cee'd JD Service Manual: Description and operation
Description This specification applies to HCU(Hydraulic Control Unit) and ECU(Electronic Control Unit) of the HECU.(Hydraulic and Electronic Control Unit) This specification is for the wiring design and installation of ABS ECU. This unit has the functions as follows. ...

© 2017-2025 www.kceed.com