Kia Cee'd: Manual Transaxle System / Neutral Switch Repair procedures

Kia Cee'd JD Service Manual / Manual Transaxle System / Manual Transaxle System / Neutral Switch Repair procedures

Inspection

1.	Remove the air cleaner assembly. (Refer to Engine Mechanical System - "Air Cleaner)

2.	Disconnect the neutral switch connector (A).

3.	Check the continuity between power terminal and signal terminal.

Removal

1.	Remove the air cleaner assembly. (Refer to Engine Mechanical System - "Air Cleaner)

2.	Disconnect the neutral switch connector (A).

Remove the neutral switch.

Tightening torque :

39.2 ~ 58.8 N.m (4.0 ~ 6.0 kgf.m, 28.9 ~ 43.4 lb-ft)

Installation

Install in the reverse order of removal

The neutral switch must be replaced with new one.

Neutral Switch Description and operation

Description • Signal of neutral switch is transmitted to the ECM in the neutral state. • This signal is blocked when gear changed ...

Manual Transaxle Control System

...

Other information:

Kia Cee'd JD Service Manual: Repair procedures
Inspection 1. Check the clutch release cylinder for fluid leakage. 2. Check the clutch release cylinder boot for damage. Removal 1. Drain the brake fluid through the bleed plug (A). ...

Kia Cee'd JD Service Manual: Troubleshooting
Troubleshooting Problem Possible cause Solution Not pairing Bluetooth device of Car is not discoverable mode Enter Bluetooth pairing (searching) mode User’s phone is Bluetooth off ...