Kia Cee'd: Lane Departure Warning System (LDWS) / Lane Departure Warning System (LDWS) Unit Repair procedures

Kia Cee'd JD Service Manual / Body Electrical System / Lane Departure Warning System (LDWS) / Lane Departure Warning System (LDWS) Unit Repair procedures

Removal

1.	Disconnect the negative (-) battery terminal.

2.	Remove the mirror wiring cover (A).

3.	Remove the LDWS unit cover (A).

4.	Disconnect the LDWS unit connector (A).

5.	Remove the LDWS unit (A) after widening the mounting clips.

Installation

1.	Install the LDWS unit.

Install the LDWS unit cover.

After replacing the LDWS unit, It is necessary to operate the Variant Coding procedure and Calibration procedure.

a.	Using the GDS tool, select the Variant Coding menu of LDWS and select the RHD or LHD.

b.	Using the GDS tool, operate the Calibration menu of LDWS.

c.	Ignition OFF and ON.

d.	Check the normal operation of LDWS.

3.	Check LDWS system operation.

Lane Departure Warning System (LDWS) Unit Components and components location

Components ...

Blind Spot Detection system

...

Other information:

Kia Cee'd JD Service Manual: PTC Heater (Diesel Engine) Repair procedures
Inspection Operating Logic Test (Manual only) Inspect the PTC operation with the confirmation logic below : 1. Entering (1) Set the Floor mode and maximum heating position. (2) ...

Kia Cee'd JD Owners Manual: Windshield washers (front)
In the O (Off) position, pull the lever gently toward you to spray washer fluid on the windshield and to run the wipers 1-3 cycles. Use this function when the windshield is dirty. The spray and wiper operation will continue until you release the lever. If the washer does not work, che ...