Kia Cee'd: Front Seat / Front Seat Shield Outer Cover Repair procedures
| • |
Put on gloves to protect your hands.
|
|
| • |
Use a plastic panel removal tool to remove interior trim pieces
to protect from marring the surface.
|
| • |
Take care not to bend or scratch the trim and panels.
|
|
| 1. |
Using a screwdriver or remover, remove the front seat shield outer cover
(A).

|
| 2. |
Disconnect the power seat switch connector (A).

|
| 3. |
Install in the reverse order of removal.
| •
|
Replace any damaged clips.
|
| •
|
Make sure the connector is plugged in properly.
|
|
|
[3Door]
| • |
Put on gloves to protect your hands.
|
|
| • |
Use a plastic panel removal tool to remove interior trim pieces
to protect from marring the surface.
|
| • |
Take care not to bend or scratch the trim and panels.
|
|
| 1. |
Remove the height adjust lever cap (A).
|
| 2. |
After loosening the mounting screw, then remove the height adjust lever
(B).

|
| 3. |
Remove the handwheel recliner (A).

|
| 4. |
After loosening the mounting screw, then remove the front seat shield
outer cover (A).

|
| 5. |
Disconnect the lumbar support switch connector (A).

|
| 6. |
Install in the reverse order of removal.
| •
|
Replace any damaged clips.
|
| •
|
Make sure the connector is plugged in properly.
|
|
|
Component Location
1. Front seat shield outer cover
...
Component Location
1. Front seat shield inner cover
...
Other information:
: Switching Pre-Collision Assist On and Off
You cannot switch the system off.
Adjusting the Pre-Collision Assist Settings
You can adjust the following settings by
using the touchscreen controls in the
pre-collision assist menu:
Change alert and distance alert
sensitivity to one of three possible
settings.
Switch distance indication a ...
Kia Cee'd JD Owners Manual: Using Radio Mode
Selecting/Saving Presets
Press the 1~6 buttons to play
the desired preset.
Press the button to display the
broadcast information for the frequency
saved to each button.
✽ NOTICE
While listening to a frequency you
want to save as a preset, press and
hold one of the 1~6 preset but ...