Kia Cee'd: Dual Clutch Transmission Control System / Description and operation

The Dual Clutch Transmission (DCT) control system measures required data to identify the state of the control target and computes the appropriate compensation value if adjustment is necessary. The actuator is controlled according to the computed compensation value to obtain desired output.

If transmission or driving-performance-related failure is detected, first perform self-diagnosis and basic transmission inspection (oil check).

Then use the diagnostic tool to inspect the transmission control system components.

Dual Clutch Transmission Control System

...

Components and components location

Component Location   1. Even clutch actuator motor 2. Input shaft speed sensor 2 3. Intput shaft speed sensor 1 4. Gear Actuator 5. Inhibitor switch ...

Other information:

Kia Cee'd JD Service Manual: Repair procedures
Inspection 1. After disconnecting the vapor hose from the PCV valve, remove the PCV valve. 2. Reconnect the PCV valve to the vapor hose. 3. Run the engine at idle, then put a finger over the open end ...

Kia Cee'd JD Owners Manual: Non-operating condition
The sensors are located inside of the rear bumper. Always keep the rear bumper clean for the system to work properly. WARNING The warning light on the outside rearview mirror will illuminate whenever a vehicle is detected at the rear side by the system. To avoid accidents, do ...