Kia Cee'd: SRSCM / Front Impact Sensor (FIS) Repair procedures

Kia Cee'd JD Service Manual / Restraint / SRSCM / Front Impact Sensor (FIS) Repair procedures

Removal
  
•
Removal of the airbag must be performed according to the precautions/ procedures described previously.
•
Before disconnecting the front impact sensor connector, disconnect the front airbag connector(s).
•
Do not turn the ignition switch ON and do not connect the battery cable while replacing the front impact sensor.
1.
Disconnect the battery negative cable, and wait for at least three minutes before beginning work.
2.
Left side - Remove the head lamp assembly.
(Refer to Body electrical - "Head Lamps")
Right side - Remove the washer reservoir.
(Refer to Body electrical - "Front washer motor")
3.
Disconnect the front impact sensor connector (A).

4.
Remove the front impact sensor mounting nut (B).
Installation
  
•
Do not turn the ignition switch ON and do not contact the battery cable while replacing the front impact sensor.
1.
Install the new front impact sensor.
2.
Tighten the front impact sensor mounting nut.
Tightening torque :
6.8 ~ 7.9 N.m (0.7 ~ 0.8 kgf.m, 5.0 ~ 5.8 lb-ft)
3.
Connect the front impact sensor connector.
4.
Left side - Install the head lamp assembly.
(Refer to Body electrical - "Head Lamps")
Right side - Install the washer reservoir.
(Refer to Body electrical - "Front washer motor")
5.
Reconnect the battery negative cable.
6.
After installing the Front Impact Sensor, confirm proper system operation:
•
Turn the ignition switch ON; the SRS indicator light should be turned on for about six seconds and then go off.
Front Impact Sensor (FIS) Components and components location
Components ...

Side Impact Sensor (SIS) Description and operation
Description The Side Impact Sensor (SIS) system consists of two front SIS which are installed inside the Center Pillar (LH and RH). They are remote sensors that detect acceleration ...

Other information:

: Locating the Pre-Collision Assist Sensors
Camera. Radar sensor (if equipped). If a message regarding a blocked sensor or camera appears in the information display, something is obstructing the radar signals or camera images. The radar sensor is behind the fascia cover in the center of the lower grille. With a blocked sensor or ca ...

Kia Cee'd JD Owners Manual: Fuel gauge
The fuel gauge indicates the approximate amount of fuel remaining in the fuel tank. ✽ NOTICE The fuel tank capacity is given in chapter 8. The fuel gauge is supplemented by a low fuel warning light, which will illuminate when the fuel tank is nearly empty. On inclines or ...

© 2017-2026 www.kceed.com