Kia Cee'd: Fuel Delivery System / Filler-Neck Assembly Repair procedures

Kia Cee'd JD Service Manual / Fuel System / Fuel Delivery System / Filler-Neck Assembly Repair procedures

Removal
1.
Lift the vehicle.
2.
Disconnect the fuel filler hose (A), leveling hose (B) and the ventilation hose (C).

3.
Open the fuel filler door and then remove the filler-neck installation screw (A).

4.
Remove the rear-LH wheel, tire, and the inner wheel house (A).

5.
Remove the filler-neck assembly from the vehicle after removing the bracket installation bolt (A).

Installation
1.
Installation is reverse of removal.
Filler-neck assembly bracket installation bolt :
3.9 ~ 5.9 N.m (0.4 ~ 0.6 kgf.m, 2.9 ~ 4.3 lb-ft)
Filler-neck assembly installation screw :
7.8 ~ 11.8 N.m (0.8 ~ 1.2 kgf.m, 5.8 ~ 8.7 lb-ft)
Fuel Line Repair procedures
Removal 1. Turn the ignition switch OFF, and then remove battery (-) cable. 2. Release the residual pressure in fuel line. ( ...

Accelerator Pedal Repair procedures
Removal 1. Turn the ignition switch OFF and disconnect the negative (-) battery cable. 2. Disconnect the accelerator position sens ...

Other information:

Kia Cee'd JD Service Manual: Troubleshooting
Troubleshooting   Symptom Suspect area Engine will not start or struggle to start Vapor hose damaged or disconnected Engine struggles to start Malfunction of the Purge Control Solenoid Valve ...

Kia Cee'd JD Owners Manual: Auto stop indicator
This indicator will illuminate when the engine enters the Idle Stop mode of the ISG (Idle Stop and Go) system. When the automatic starting occurrs, the auto stop indicator on the cluster will blink for 5 seconds. For more details, refer to the ISG (Idle Stop and Go) system in chapter 5 ...

© 2017-2026 www.kceed.com