Kia Cee'd: Timing System / Crankshaft Damper Pulley Repair procedures

Kia Cee'd JD Service Manual / Engine Mechanical System / Timing System / Crankshaft Damper Pulley Repair procedures

Removal and Installation

1.	Remove the drive belt. (Refer to Timing System - "Dreve Belt")

2.	Remove the engineroom under cover.

3.	Remove the passenger side front tire.

Remove the crankshaft damper pulley (A).

Tightening torque :

46.1 ~ 52.0 N.m (4.7 ~ 5.3 kgf.m, 34.0 ~ 38.3 lb-ft) + 38 ~ 42°

There are two methods to hold the ring gear when installing or removing the crankshaft damper pulley.

•	Install the SST (09231-2B100) to hold the ring gear after removing the starter.

•	Install the SST (09231-3D100) to hold the ring gear after removing the dust cover.

1)	Remove the bracket (A).

2)	Remove the dust cover (A) and unfasten the transaxle mounting bolt (B).

3)	Adjust the length of the holder nuts (A) so that the front plate of the holder (B) puts in the ring gear (C) teeth.

4)	Adjust the angle of the links (D), and fasten the bolt 70mm(2.7559in) in the original mounted hole.

5)	Tighten the bolts and nuts of the holder and links securely.

5.	When installing the pulley, the groove on the pulley should be positioned outside.

Crankshaft Damper Pulley Components and components location

Components 1. Crankshaft damper pulley ...

Front Oil Seal Components and components location

Components 1. Front oil seal ...

Other information:

: Switching the Rear Window Wiper On and Off. Reverse Wipe
Switching the Rear Window Wiper On and Off Intermittent wipe. Continuous wipe. Rear window wiper off. Reverse Wipe What Is Reverse Wipe Reverse wipe turns on the rear window wiper when you shift into reverse (R) and the windshield wipers are on. Reverse Wipe Settings Press Settings on the ...

Kia Cee'd JD Owners Manual: Operating conditions
To operate: Press the BSD switch with the Ignition switch in the ON position. The indicator on the BSD switch will illuminate. When the vehicle speed exceeds 30 km/h (20 mph), the system will be activated. To cancel: Press the BSD switch again. The indicator on the switch will go off. W ...