Kia Cee'd: Driveshaft Assembly / BJ Boot Repair procedures

Replacement
1.
Remove the front driveshaft.
(Refer to Driveshaft Assembly - “Front Driveshaft”)
2.
Remove the TJ joint assembly.
(Refer to Driveshaft Assembly - “TJ Joint”)
3.
Remove the Dynamic damper.
(Refer to Driveshaft Assembly - “Dynamic Damper”)
4.
Using a plier or flat-tipped (-) screwdriver, remove the BJ boot bands (A).

5.
Remove the BJ boot.
6.
Install in the reverse order of removal.
  
•
Do not disassemble the BJ assembly.
•
Special grease must be applied to the driveshaft joint. Do not substitute with another type of grease.
•
The boot band should be replaced with a new one.
BJ Boot Components and components location
Components   1. BJ assembly 2. BJ circlip 3. BJ boot band 4. BJ boot 5. Dynamic damper band 6. Dynamic damper 7. Shaft 8. TJ boo ...

Rear Axle Assembly / Rear Hub - Carrier
...

Other information:

Kia Cee'd JD Service Manual: Rear Glass Defogger Printed Heater Repair procedures
Inspection    Wrap tin foil around the end of the voltmeter test lead to prevent damaging the heater line. Apply finger pressure on the tin foil, moving the tin foil along the grid line to check for open c ...

Kia Cee'd JD Owners Manual: Speed limiter indicator
The indicator illuminates when the speed limit control system is enabled by move the lever up on the steering wheel. The indicator goes off when the lever up again to deactivate the system. If there is a problem with the speed limit control system, the “---” indicator will blin ...

© 2017-2026 www.kceed.com