Kia Cee'd: Troubleshooting / Auto Defogging Sensor Description and operation

Kia Cee'd JD Service Manual / Heating,Ventilation, Air Conditioning / Troubleshooting / Auto Defogging Sensor Description and operation

Description
The auto defogging sensor is installed on the front window glass. The sensor judges and sends signal if moisture occurs to blow out wind for defogging. The air conditioner control module receives signal from the sensor and restrains moisture and eliminate defog by controlling the intake actuator, A/C, auto defogging actuator, blower motor rpm, mode actuator.

Ambient Temperature Sensor Repair procedures
Inspection 1. Turn the ignition switch OFF. 2. Disconnect the ambient temperature sensor. 3. Check the re ...

Auto Defogging Sensor Repair procedures
Inspection To inspect and diagnose the sensor, refer to Self-Diagnosis procedure and DTC guide. Replacement 1. Disconnect the negative (-) battery ...

Other information:

Kia Cee'd JD Service Manual: Crankshaft Damper Pulley Repair procedures
Removal and Installation 1. Remove the drive belt. (Refer to Timing System - "Dreve Belt") 2. Remove the engineroom under cover. 3. Remove the passenger side front tire. ...

Kia Cee'd JD Service Manual: IMS Power Seat Control Repair procedures
Inspection 1. Disconnect the IMS control switch connector. 2. With the power IMS control switch in each position, make sure that continuity exists between the terminals below. If continuity is not as specified, replace ...

© 2017-2019 www.kceed.com