Kia Cee'd: Wipers and washers / Windshield wipers (front)

Operates as follows when the ignition switch is turned ON.

: For a single wiping cycle, move the lever to this position and release it. The wipers will operate continuously if the lever is held in this position.

O : Wiper is not in operation

--- :Wiper operates intermittently at the same wiping intervals. Use this mode in light rain or mist.To vary the speed setting, turn the speed control knob.

1 : Normal wiper speed

2 : Fast wiper speed

✽ NOTICE

If there is heavy accumulation of snow or ice on the windshield, defrost the windshield for about 10 minutes, or until the snow and/or ice is removed before using the windshield wipers to ensure proper operation. If you do not remove the snow and/or ice before using the wiper and wash-er, it may damage the Wiper and washer system.

Wipers and washers
■ Front ■ Rear A :Wiper speed control (front) · 2 – High wiper speed · 1 – Low wiper speed · --- – Intermittent wipe · AUTO* – Automatic control wipe · O – Off · – Si ...

AUTO (Automatic) control
The rain sensor located on the upper end of the windshield glass senses the amount of rainfall and controls the wiping cycle for the proper interval. The more it rains, the faster the wiper ...

Other information:

Kia Cee'd JD Service Manual: ESP OFF Switch Description and operation
Description • 1st stage The ESP engine control function will stop when the ESP OFF indicator on the cluster turns on by pressing the ESP OFF button for 0.15 second. (The brake control function works normally.) • 2 ...

Kia Cee'd JD Service Manual: Audio Remote Control Repair procedures
Inspection Type A 1. Check the audio remote control switch (A) for resistance between terminals in each switch position. [Audio]   Switch Connector terminal Res ...

© 2017-2023 www.kceed.com