Kia Cee'd: Windshield Wiper/Washer / Windshield Wiper-Washer Switch Repair procedures

Kia Cee'd JD Service Manual / Body Electrical System / Windshield Wiper/Washer / Windshield Wiper-Washer Switch Repair procedures

Inspection

Check for continuity between the terminals while operating the wiper and washer switch. If it is not normal condition, replace wiper and wiper switch.

Wiper Switch

Washer Switch

Rear Wiper Switch

Rear Washer Switch

Removal

1.	Remove the steering column shroud lower / upper panel. (Refer to Body - "Steering Column Shroud Panel")

2.	Disconnect the connector (A).

3.	If it is necessary to remove. The wiper & washer switch (A) only, release the lock of wiper switch using tool without removing the steering wheel and the clock spring.

4.	Remove the steering wheel. (Refer to Steering System - "Steering Wheel")

5.	Remove the clock spring. (Refer to Restraint - "Driver Airbag (DAB) and Clock Spring")

6.	Remove the multifunction switch assembly (A) after loosening 2 screws.

Installation

1.	Install the multifunction switch after connecting the connector.

2.	Install the clock spring and steering.

3.	Install the upper and lower shroud.

4.	Install the steering wheel.

Components and components location

Component Location 1. Windshield wiper arm & blade 2. Wiper & washer switch 3. Windshield washer hose 4. Windshield wiper motor & linkage ...

Front Wiper Motor Components and components location

Component Location 1. Cap 2. Nut 3. Wiper arm & blade 4. Rivet 5. Cowl top cover 6. Bolt 7. Wiper motor & linkage assembly ...

Other information:

Kia Cee'd JD Service Manual: Trailing Arm Repair procedures
Replacement 1. Loosen the wheel nuts slightly. Raise the vehicle, and make sure it is securely supported. 2. Remove the rear wheel and tire (A) from rear hub. Tightening torque: 88.2 ~ 1 ...

Kia Cee'd JD Owners Manual: Instant fuel economy (L/100 km or MPG)
This mode calculates the instant fuel consumption during the last few seconds. ✽ NOTICE If the vehicle is not on level ground or the battery power has been interrupted, the “Distance to empty” function may not operate correctly. The trip computer may not register additi ...