Kia Cee'd: Cooling System / Water Temperature Control Assembly Repair procedures

Kia Cee'd JD Service Manual / Engine Mechanical System / Cooling System / Water Temperature Control Assembly Repair procedures

Removal and Installation
1.
Loosen the drain plug, and drain the engine coolant. Remove the radiator cap to drain with speed.
2.
Disconnect the battery negative terminal.
3.
Remove the air cleaner assembly.
(Refer to Intake and exhaust system - "Air Cleaner")
4.
Disconnect the water temperature sensor connector.
(Refer to Fuel System - "Engine Control System")
5.
Disconnect the radiator upper hose.
6.
Remove the heater hose.
7.
Remove the water temperature control assembly (B) after disconnecting the water hose (A).
Tightening torque :
9.8 ~ 11.7N.m (1.0 ~ 1.2kgf.m, 7.2 ~ 8.7lb-ft)

8.
Install in the reverse order of removal.
  
Clean the surface of the water temperature control assembly before installing.
Water Temperature Control Assembly Components and components location
Components   1. Water temperature control assembly 2. Water temperature sensor 3. Gasket 4. Water 5. Bypass hose ...

Water pump Components and components location
Components   1. Gasket 2. Water pump 3. Water pump pulley ...

Other information:

Kia Cee'd JD Service Manual: Troubleshooting
TPMS Inspection method Inspection    Find the inspection number by referring to the table above. The following content is irrelevant of the inspection procedure. 1. ...

Kia Cee'd JD Service Manual: Compressor Repair procedures
Removal 1. If the compressor is marginally operable, run the engine at idle speed, and let the air conditioning work for a few minutes, then shut the engine off. 2. Disconnect the negative cable from the battery. ...

© 2017-2025 www.kceed.com