Kia Cee'd: Cooling System / Water pump Repair procedures

Kia Cee'd JD Service Manual / Engine Mechanical System / Cooling System / Water pump Repair procedures

Removal

Loosen the drain plug (A), and drain the engine coolant. Remove the radiator cap to drain with speed.

System is under high pressure when the engine is hot.To avoid danger of releasing scalding engine coolant, remove the cap only when the engine is cool.

2.	Remove the drive belt. (Refer to Timing System - "Drive Belt")

Remove the water pump pulley(A).

Tightening torque :

9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 lb-ft)

4.	Remove the water pump(A).

Inspection

1.	Check each part for cracks, damage or wear, and replace the coolant pump assembly if necessary.

2.	Check the bearing for damage, abnormal noise and sluggish rotation, and replace the coolant pump assembly if necessary.

Check for coolant leakage. If coolant leaks from hole, the seal is defective. Replace the coolant pump assembly and gasket.

A small amount of “weeping” from the bleed hole is normal.

Installation

Install the new gasket and water punp(A).

Tightening torque :

9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 lb-ft)

Install the water pump pulley.

Tightening torque :

9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 lb-ft)

Tighten the bolts diagonally when installing.

3.	Remove the drive belt. (Refer to Timing System - "Drive Belt")

4.	Fill with engine coolant.

5.	Start engine and check for leaks.

6.	Recheck engine coolant level.

Water pump Components and components location

Components 1. Gasket 2. Water pump 3. Water pump pulley ...

Water pump Troubleshooting

Troubleshooting Symptoms Possible Causes Remedy Coolant leakage • From the bleed ...

Other information:

Kia Cee'd JD Owners Manual: In case of an emergency while driving
If the engine stalls at a crossroad or crossing If the engine stalls at a crossroad or crossing, set the shift lever in the N (Neutral) position and then push the vehicle to a safe place. If your vehicle has a manual transaxle not equipped with a ignition lock switch, the vehi ...

Kia Cee'd JD Service Manual: Description and operation
Description Exhaust emissions (CO, HC, NOx) are controlled by a combination of engine modifications and the addition of special control components. Modifications to the combustion chamber, intake manifold, camshaft and ignition system form the basic control system. Th ...