Kia Cee'd: Engine Control System / Variable Intake Solenoid (VIS) Valve Repair procedures

Kia Cee'd JD Service Manual / Fuel System / Engine Control System / Variable Intake Solenoid (VIS) Valve Repair procedures

Inspection

1.	Turn the ignition switch OFF.

2.	Disconnect the VIS valve connector.

Measure resistance between VIS valve terminals 1 and 2.

Specification: Refer to "Specification"

Removal

1.	Turn the ignition switch OFF and disconnect the battery negative (-) cable.

2.	Disconnect the variable intake solenoid valve connector (A).

3.	Disconnect the vacuum hoses (B) from the valve.

4.	Remove the installation bolt, and then remove the valve (C) from the surge tank.

Installation

•	Install the component with the specified torques.

•	Note that internal damage may occur when the component is dropped. If the component has been dropped, inspect before installing.

•	Use care to keep foreign material out of the valve.

1.	Installation is reverse of removal.

Variable Intake Solenoid (VIS) Valve Schematic diagrams

Circuit Diagram ...

Fuel Pressure Control Valve Description and operation

Description Fuel Pressure Regulator Valve is installed on the high pressure fuel pump and controls fuel flow flowing into the injectors in accordance with the ECM signal calculat ...

Other information:

Kia Cee'd JD Service Manual: Temperature Control Actuator Repair procedures
Inspection 1. Turn the ignition switch OFF. 2. Disconnect the temperature control actuator connector. 3. Verify that the temperature control actuator operates to the warm position when connecting 12V ...

Kia Cee'd JD Owners Manual: Explanation of scheduled maintenance items
Engine oil and filter The engine oil and filter should be changed at the intervals specified in the maintenance schedule. If the car is being driven in severe conditions, more frequent oil and filter changes are required. Drive belts Inspect all drive belts for evidence of cuts, cracks, ...