Park the vehicle and stop the engine. Arm the system as described below.
1.Turn off the engine and remove the ignition key from the ignition switch.
2.Make sure that all doors, the engine hood and tailgate are closed and latched.
3.Lock the doors by pressing the lock button on the transmitter.
After completion of the steps above, the hazard warning lights will blink once to indicate that the system is armed.
If the tailgate or engine hood remains opened, the hazard warning lights will not operate and theft-alarm will not arm. After this, if the tailgate and engine hood are closed, the hazard warning lights will blink once and the theft-alarm will arm.
• Do not arm the system until all passengers have left the vehicle. If the system is armed while a passenger( s) remains in the vehicle, the alarm may be activated when the remaining passenger(s) leave the vehicle. If any door, tailgate or engine hood is opened within 30 seconds after entering the armed stage, the system is disarmed to prevent unnecessary alarm.
Kia Cee'd JD Owners Manual: Storing positions into memory using
the buttons on the door
Storing driver’s seat positions
1. Shift the shift lever into P or N (for
Automatic transaxle) or Neutral (for
manual transaxle) while the engine
start/stop button is ON or ignition
switch ON.
2. Adjust the driver’s seat comfortable for
the driver.
3. Press SET button on the control ...
Kia Cee'd JD Service Manual: Camshaft Position Sensor (CMPS) Repair procedures
Inspection
1.
Check the signal waveform of the CMPS and CKPS using the GDS.
Specification: Refer to “Wave Form”
Removal
...