| Engine Overheat Troubleshooting |
|
Inspection |
Remedy |
||||||||
|
Visual inspection |
Inspect for shortage of coolant in reservoir tank . |
Reinspect after replenishing coolant. |
|||||||
Inspect for coolant pollution after removing radiator cap.
|
Reinspect after replacing coolant. |
||||||||
|
Inspect for leakage and loose coolant hoses (radiator hose, heater hose,
oil cooler hose, etc.). |
Reinspect for leakage after reinstalling hoses and clamps. |
||||||||
|
Inspect for leakage on water inlet fitting mounting part. |
Reinspect for leakage after replacing O-ring. |
||||||||
|
Reinspect for leakage after tightening to the specified torque. |
|||||||||
|
Inspect drive belt (for normal operation of water pump). |
Adjust drive belt tension or replace. |
||||||||
|
Inspect for leakage on water pump gasket mounting part. |
Reinspect for leakage after replacing gasket. |
||||||||
|
Reinspect for leakage after tightening to the specified torque. |
|||||||||
|
Inspect for loose coolant temperature sensor, cooling fan connector and
pin. |
Reinstall loose connector. |
||||||||
|
Replace relevant part if connector pin is damaged. |
|||||||||
|
Inspect operation status of cooling fan. - Check operation status by switching ON/OFF the heater control A/C.
|
Check mounting status of ground cable. |
||||||||
|
Diagnostic device |
Inspect self-diagnostic code using KDS/GDS. |
Check coolant temperature sensor, wiring, connector, etc. |
|||||||
|
Unit inspection |
Inspect water pump impeller. |
Replace water pump. |
|||||||
|
Inspect for foreign materials and status of thermostat valve. |
Inspect unit after removing foreign materials. |
||||||||
|
Inspect for stuck thermostat valve. - Immerse thermostat in water heated to over 95°C (203°F), then heat for at least 3 minutes to check valve lift.
|
Check valve lift. - Replace thermostat if valve lift is below specification or valve is stuck. |
||||||||
Cooling System
Coolant Repair proceduresKia Cee'd JD Owners Manual: Cruise Control system
■ Normal vision
■ Supervision
1. Cruise indicator
2. Cruise set indicator
The cruise control system allows you to
program the vehicle to maintain a constant
speed without pressing the accelerator
pedal.
This system is designed to function
above approximately 30 km/h (20 mph).
W ...
Kia Cee'd JD Service Manual: Description and operation
Description
Limitations Of The Navigation system
GPS Signal Reception State
As the GPS satellite frequency is received/transmitted in straight lines, reception
may not work if hiding devices are placed on or near the GPS antenna or when
traveling through the following l ...