Kia Cee'd: General Information / Troubleshooting

Troubleshooting
 
Trouble Symptom
Probable cause
Remedy
Vehicle pulls to one side
Scoring of driveshaft ball joint
Replace
Wear, rattle or scoring of wheel bearing
Replace
Defective front suspension and steering
Adjustment or Replace
Vibration
Wear, damage or bending of driveshaft
Replace
Driveshaft rattle and hub serration
Replace
Wear, rattle or scratching of wheel bearing
Replace
Shimmy
Defective wheel balance
Adjustment or Replace
Defective front suspension and steering
Adjustment or Replace
Excessive noise
Wear, damage or bending of driveshaft
Replace
Rattle of driveshaft and worn hub splines
Replace
Wear, rattle or scoring of wheel bearing
Replace
Loose hub nut
Adjustment or Replace
Defective front suspension and steering
Adjustment or Replace

Special service tools
Special Service Tools   Tool(Number and Name) Illustration Use 09495-3K000 Band installer Inst ...

Front Axle Assembly / Front Hub / Knuckle
...

Other information:

Kia Cee'd JD Service Manual: Alternator Components and components location
Components   1. OAD (Overrunning Alternator Decoupler) 2. Front Bracket 3. Front Bearing 4. Stator 5. Rotor 6. Rear Bearing 7. Rear Bracket 8. Brush Holder Assembly 9. Through Bolt 10. Rectifier Assembly 11. Rear Cov ...

Kia Cee'd JD Service Manual: Input Speed Sensor 1 Repair procedures
Inspection Refer to DTC code "P2765, P2766" Input Shaft Speed Sensor. Removal 1. Turn off the ignition switch and then disconnect the battery (-) cable. 2. Remove the under cover. 3. ...

© 2017-2025 www.kceed.com