Kia Cee'd: Manual Transaxle System / Troubleshooting

Troubleshooting
 
Trouble symptom
Suspect area
Remedy 
Abnormal noise
Oil level (Low)
To adding oil after inspect the parts. (oil seal, drain plug, filler plug)
Oil (Wrong or contaminated)
Replace the oil.
Transaxle and engine mounting state (Wrong)
Tighten the mounting bolt with specified torque.
Shaft end play (Wrong)
Adjust the end play.
Synchronizer ring (Worn or damaged)
Replace the synchronizer ring.
Gear (Worn or damaged)
Replace the gear.
Bearing (Worn or damaged)
Replace the bearing.
Oil leak
Oil level (High)
Inspect the oil level.
Gasket (Damaged)
Replace the gasket. (drain plug, filler plug)
Oil seal (Worn or damaged)
Replace the oil seal.
Hard shifting or impossible to shift
Oil (Wrong)
Replace the oil.
Shift fork (Worn)
Replace the shift fork.
Synchronizer ring (Worn or damaged)
Replace the synchronizer ring.
Gear (Worn or damaged)
Replace the gear.
Hub sleeve (Worn or damaged)
Replace the hub sleeve.
Jumps out of gear
Shift fork (Worn)
Replace the shift fork.
Hub sleeve (Worn or damaged)
Replace the hub sleeve.
Gear (Worn or damaged)
Replace the gear.
Bearing (Worn or damaged)
Replace the bearing.

Special service tools
Special Service Tools   Tool Name / Number Illustration Description Engine support fixture (bar) 09200-3N000 ...

Manual Transaxle System
...

Other information:

Kia Cee'd JD Service Manual: Vacuum Pump Repair procedures
Removal Gamma 1.6 T-GDI 1. Turn ignition switch OFF and disconnect the negative (-) battery cable. 2. Remove the under covers (A). Tightening torque: 3.9 ~ 5.9 N.m (0.4 ~ 0.6 kgf.m, 2.9 ~ ...

Kia Cee'd JD Owners Manual: Non-operational conditions of parking assist system
Parking assist system may not operate normally when: 1. Moisture is frozen to the sensor. (It will operate normally when moisture melts.) 2. Sensor is covered with foreign matter, such as snow or water, or the sensor cover is blocked. (It will operate normally when the material is remo ...

© 2017-2025 www.kceed.com