Kia Cee'd: Warnings and indicators (Instrument cluster) / Tire Pressure Monitoring System (TPMS) indicator
Low tire pressure telltale/ TPMS malfunction indicator
The low tire pressure telltale comes on for 3 seconds after the ignition switch is turned to the ON position.
The low tire pressure and position telltales illuminates when one or more of your tires is significantly underinflated.
The TPMS malfunction indicator will illuminate after it blinks for approximately one minute when there is a problem with the Tire Pressure Monitoring System.
If this occurs, we recommend that the system be checked by an authorized Kia dealer.
For more details, refer to the TPMS in chapter 6.
The low tire pressure position telltale illuminates on the LCD display.
WARNING - Safe stopping
- The TPMS cannot alert you to severe and sudden tire damage caused by external factors.
- If you notice any vehicle instability, immediately take your foot off the accelerator pedal, apply the brakes gradually and with light force, and slowly move to a safe position off the road.
Charging system warning
light
This warning light indicates a malfunction
of either the generator or electrical
charging system.
If the warning light comes on while the
vehicle is in motion:
1. Drive to the nearest safe l ...
Engine oil pressure warning
This warning light indicates the engine oil
pressure is low.
If the warning light illuminates while driving:
1. Drive safely to the side of the road and
stop.
2. With the engine off, check th ...
Other information:
Kia Cee'd JD Owners Manual: Checking the amount of air conditioner
refrigerant and compressor
lubricant
When the amount of refrigerant is low,
the performance of the air conditioning is
reduced. Overfilling also has a bad influence
on the air conditioning system.
Therefore, if abnormal operation is found,
we recommend that the system be inspected
by an authorized Kia dealer.
WARNING - Vehi ...
Kia Cee'd JD Service Manual: Alternator Repair procedures
Removal
1.
Disconnect the battery negative terminal.
2.
Loosen the mounting bolts (A) and then, turn the adjusting bolt (B)
clockwise to loosen tension.
3.
Remove the drive belt (A).
...
