Kia Cee'd: Heater / Temperature Control Actuator Description and operation

The heater unit includes mode control actuator and temperature control actuator.

The temperature control actuator is located at the heater unit. It regulates the temperature by the procedure as follows. Signal from the control unit adjusts the position of the temperature door by operating temperature switch and then temperature will be regulated by the hot/cold air ratio decided by the position of tne temperature door.

Evaporator Core Repair procedures

Replacement 1. Disconnect the negative (-) battery terminal. 2. Remove the heater & blower assembly. (Refer to Heater - &q ...

Temperature Control Actuator Repair procedures

Inspection 1. Turn the ignition switch OFF. 2. Disconnect the temperature control actuator connector. 3. ...

Other information:

Kia Cee'd JD Service Manual: Description and operation
Description Clutch switch is connected to clutch pedal and transmits clutch operating state to ECM. When clutch pedal is depressed during driving, engine load changes from loaded to none loaded condition. However, ECM regards vehicle to be loaded becuase VSS signal is s ...

Kia Cee'd JD Service Manual: Input Speed Sensor 1 Description and operation
Description The input shaft speed sensor is important in that it detects the input shaft RPM and sends this information to the Transmission Control Module (TCM). It provides important input information for electric control. The information is needed in all operations, i ...