Storing driver’s seat positions
1. Shift the shift lever into P or N (for Automatic transaxle) or Neutral (for manual transaxle) while the engine start/stop button is ON or ignition switch ON.
2. Adjust the driver’s seat comfortable for the driver.
3. Press SET button on the control panel. The system will beep once.
4. Press one of the memory buttons (1 or 2) within 5 seconds after pressing the SET button. The system will beep twice when memory has been successfully stored.
Recalling positions from memory
1. Shift the shift lever into P or N (for Automatic transaxle) or Neutral (for manual transaxle) while the engine start/stop button is ON or ignition switch ON.
2. To recall the position in the memory, press the desired memory button (1 or 2). The system will beep once, then the driver’s seat will automatically adjust to the stored position.
Adjusting the control switch for the driver’s seat while the system is recalling the stored position will cause the movement to stop and move in the direction that the control switch is moved.
WARNING
Use caution when recalling the adjustment memory while sitting in the vehicle. Push the seat position control switch to the desired position immediately if the seat moves too far in any direction.
Kia Cee'd JD Service Manual: Water Jacket Insert Repair procedures
Remove and Installation
1.
Remove the cylinder head assembly.
(Refet to Cylinder Head Assembly - "Cylinder Head")
2.
Remove the water jacket Insert (A).
...
Kia Cee'd JD Service Manual: Repair procedures
On-vehicle Inpection
•
First of all, check for DTCs. If a DTC is present, perform troubleshooting
in accordance with the procedure for that DTC. (Refer to DTC
guide)
...