Kia Cee'd: Lighting / Static bending light
While driving the corner, for your sight and safety, the static bending light turns on automatically. The system will operate automatically as follows:
- When vehicle speed is under 10km/h and steering wheel angle approximately 80 degrees.
- When vehicle speed is over 10km/h and steering wheel angle approximately 35 degrees.
- When the vehicle is at a standstill.
- When moving rearwards with one of the above conditions satisfied the lights will light up the opposite direction.
Headlight (Headlamp) welcome
function
When the headlight switch is in the ON or
AUTO position and all doors (and tailgate)
are closed and locked, if you press
the door unlock button on the transmitter
or smart key, the headlights ...
Lighting control
The light switch has a Headlight and a
Parking light position.
To operate the lights, turn the knob at the
end of the control lever to one of the following
positions:
(1) OFF position
(2) P ...
Other information:
Kia Cee'd JD Service Manual: Dual Clutch Transmission(DCT) Components and components location
Components
1. Odd clutch actuator motor
2. Even clutch actuator motor
3. Input shaft speed sensor 2
4. Intput shaft speed sensor 1
5. Inhibitor switch
6. Manual control lever
7. Shift motor
8. Select motor
9. Filler plug
...
Kia Cee'd JD Service Manual: Repair procedures
Replacement
1.
Loosen the wheel nuts slightly.
Raise the vehicle, and make sure it is securely supported.
2.
Remove the rear wheel and tire (A) from rear hub .
Tightening torque:
88.2 ~ ...
