Kia Cee'd: Starting the engine / Starting the gasoline engine

1.Carry the smart key or leave it inside the vehicle.

2.Make sure the parking brake is firmly applied.

3.Manual Transaxle - Depress the clutch pedal fully and shift the transaxle into Neutral. Keep the clutch pedal and brake pedal depressed while starting the engine.

Automatic transaxle/DCT* - Place the transaxle shift lever in P (Park).

Depress the brake pedal fully.

You can also start the engine when the shift lever is in the N (Neutral) position.

* DCT : Dual clutch transmission

4.Press the engine start/stop button. It should be started without depressing the accelerator.

5.Do not wait for the engine to warm up while the vehicle remains stationary. Start driving at moderate engine speeds. (Steep accelerating and decelerating should be avoided.)

Starting the engine
WARNING Always wear appropriate shoes when operating your vehicle. Unsuitable shoes (high heels, ski boots,etc.) may interfere with your ability to use the brake and accelerator ped ...

Starting the diesel engine
To start the diesel engine when the engine is cold, it has to be pre-heated before starting the engine and then have to be warmed up before starting to drive. 1.Make sure the parking brake is ...

Other information:

Kia Cee'd JD Owners Manual: Interior overview
1. Seat 2. Inside door handle 3. Power window switch 4. Power window lock button 5. Hood release lever 6. Outside rearview mirror folding 7. Outside rearview mirror control 8. Headlight leveling device 9. Instrument panel illumination control system 10. Idle Stop and Go (ISG) OFF button ...

Kia Cee'd JD Service Manual: Crankshaft Position Sensor (CKPS) Troubleshooting
Signal Waveform [NON-ISG] This example shows a typical Crankshaft Position Sensor(CkPS) and Camshaft Position Sensor(CMPS) waveform at idle.The PCM controls the injection and ignition timing by using these signals. Generally CkPS signal is used to dete ...

© 2017-2024 www.kceed.com