Kia Cee'd: Heating,Ventilation, Air Conditioning / Specifications

Kia Cee'd JD Service Manual / Heating,Ventilation, Air Conditioning / Specifications

Specification

Air Conditioner

Item		Specification
Compressor	Type	6VSx14 (Around Rubber Damper Type)
	Oil type & Capacity	PAG(FD46XG) 110±10cc
	Pulley type	6PK-TYPE
	Displacement	142 cc/rev
Condenser	Heat Rejection	GSL : 13,400 - 3% kcal/h DSL : 12,300 - 3% kcal/h
Expansion valve	Type	Block type
Refrigerant	Type	R-134a or R-1234yf
Refrigerant	Capacity	500 ± 25 g (17.6 ± 0.88 oz.)

Blower Unit

Item		Specification
Intake	Control Type	Actuator
Blower	Type	Sirocco
	Speed Step	DATC: Auto or 1~8 speed, MANUAL : 1~4 speed
	Speed Control	DATC : Power mosfet, MANUAL : Blower resistor
Air filter	Type	Particle filter

Heater And Evaporator Unit

Item		Specification
Heater	Type	Pin & Tube type
	Heating Capacity	4,800 - 5% kcal/hr
	Mode Control Type	Actuator
	Temperature Control Type	Actuator
Evaporator	Cooling Capacity	4,500 - 5% kcal/hr
	Temperature Control Type	Evaporator temperature sensor
	A/C ON/OFF	ON: 2.1 ± 0.5°C (35.8 ± 32.9°F) OFF: 0.6 ± 0.5°C (33.1 ± 32.9°F)

Tightening Torques

Items	N.m	kgf.m	lb-ft
Condenser - Discharge hose	7.8 ~ 11.8	0.8 ~ 1.2	5.7 ~ 8.7
Condenser - Liquid tube	7.8 ~ 11.8	0.8 ~ 1.2	5.7 ~ 8.7
Compressor	19.6 ~ 33.3	2.0 ~ 3.4	14.5 ~ 24.6
Compressor - Discharge hose	18.6 ~ 27.5	1.9 ~ 2.8	13.7 ~ 20.3
Compressor - Suction hose	18.6 ~ 27.5	1.9 ~ 2.8	13.7 ~ 20.3
Expansion valve - Evaporator	7.8 ~ 11.8	0.8 ~ 1.2	5.7 ~ 8.7

Heating,Ventilation, Air Conditioning

...

Special service tools

Special Service Tools Tool (Number and name) Illustration Use 09977-3R000 Disc & hub assembly bolt remover ...

Other information:

Kia Cee'd JD Service Manual: Front Door Outside Handle Repair procedures
Replacement [Front Door Outside Handle] 1. Remove the hole plug (B). 2. After loosening the mounting bolt, then remove the front door outside handle cover (A). Tightening torque : ...

Kia Cee'd JD Owners Manual: Fuel filter warning light (Diesel engine)
This warning light illuminates for 3 seconds after the ignition switch is set to the ON position and then it will go out. If it lights up while the engine is running, it indicates that water has accumulated inside the fuel filter. If this happens, remove the water from the fuel filter. ...