Kia Cee'd: SRSCM / Side Impact Sensor (SIS) Repair procedures

Kia Cee'd JD Service Manual / Restraint / SRSCM / Side Impact Sensor (SIS) Repair procedures

Removal
Side Impact Sensor
1.
Disconnect the battery negative cable and wait for at least three minutes before beginning work.
2.
Remove the door scuff trim.
(Refer to Body - "Door scuff trim")
3.
Remove the center pillar lower trim.
(Refer to Body - "Center pillar trim")
4.
Disconnect the side impact sensor connector (A).

5.
Loosen the side impact sensor mounting bolt and remove the side impact sensor (B).
Installation
Side Impact Sensor
  
Do not turn the ignition switch ON and do not connect the battery cable while replacing the side impact sensor.
1.
Install the new side impact sensor with the bolt then connect the side impact sensor connector.
Tightening torque :
6.8 ~ 7.9 N.m (0.7 ~ 0.8 kgf.m, 5.0 ~ 5.8 lb-ft)
2.
Install the center pillar lower trim.
(Refer to Body - "Center pillar trim")
3.
Install the door scuff trim.
(Refer to Body - "Door scuff trim")
4.
Reconnect the battery negative cable.
5.
After installing the Side Impact Sensor, confirm proper system operation:
Turn the ignition switch ON; the SRS indicator light should be turned on for about six seconds and then go off.
Side Impact Sensor (SIS) Components and components location
Components ...

PAB ON/OFF Switch Description and operation
Description Driver can control the passenger airbag operating Condition (Enable or Disable) by using this PAB ON/OFF switch. Passenger Airbag (PAB) ON/OFF Switch is installed i ...

Other information:

Kia Cee'd JD Owners Manual: Blade replacement
When the wipers no longer clean adequately, the blades may be worn or cracked, and require replacement. CAUTION To prevent damage to the wiper arms or other components, do not attempt to move the wipers manually. CAUTION The use of a non-specified wiper blade could result in wiper malf ...

Kia Cee'd JD Owners Manual: Anti-lock brake system (ABS) warning light
This light illuminates if the ignition switch is turned ON and goes off in approximately 3 seconds if the system is operating normally. If the ABS warning light remains on, comes on while driving, or does not come on when the ignition switch is turned to the ON position, this indicate ...

© 2017-2025 www.kceed.com