Removal |
The side airbag cannot be disassembled from the seat back assembly,
so replace assembly when replacing the side airbag.
|
1. |
Disconnect the battery negative cable and wait for at least thirty seconds
before beginning work.
|
2. |
Remove the front seat assembly.
(Refer to Body - "Front seat assembly")
|
3. |
Remove the seat back assembly.
(Refer to Body - "Front seat frame assembly")
|
Installation |
Be sure to install the harness wires not to be pinched or interfered
with other parts.
|
|
1. |
Remove the ignition key from the vehicle.
|
2. |
Disconnect the battery negative cable and wait for at least thirty seconds.
|
3. |
Install the new seat back assembly.
|
4. |
Install the front seat assembly.
(Refer to Body - "Front seat assembly")
|
5. |
Recline and slide the front seat forward fully, make sure the harness
wires are not pinched of interfering with other parts.
|
6. |
Reconnect the battery negative cable.
|
7. |
After installing the side airbag (SAB), confirm proper system operation:
|
Kia Cee'd JD Owners Manual: Air intake control
This is used to select the outside (fresh)
air position or recirculated air position.
To change the air intake control position,
push the control button.
Recirculated air position
With the recirculated air
position selected, air from
the passenger compartment
will be drawn through ...
Kia Cee'd JD Owners Manual: Multi fuse
If the multi fuse is blown, it must be
removed as follows:
1. Turn off the engine.
2. Disconnect the negative battery cable.
3. Remove the fuse panel on the right
side in the engine compartment.
4. Remove the nuts shown in the picture
above.
5. Replace the fuse with a new one of the
s ...