Kia Cee'd: Dual Clutch Transmission Control System / Shift Lever Repair procedures

Kia Cee'd JD Service Manual / Dual Clutch Transmission(DCT) System / Dual Clutch Transmission Control System / Shift Lever Repair procedures

Removal

1.	Remove the floor console assembly. (Refer to Body - "Floor Console")

2.	Remove the air duct.

3.	Disconnect the control cable (A).

4.	Disconnect the connector (A).

5.	Disconnect the wire mounting clips (B).

Remove the bolt and then the shift lever assembly (C).

Tightening torque:

8.8 ~ 13.7 N.m (0.9 ~ 1.4 kgf.m, 6.5 ~ 10.1 lb-ft)

Installation

Install in the reverse order of removal.

Install the cable after placing the shift lever and the transmission manual control lever in the N position.

Shift Lever Components and components location

Components 1. Shift lever assembly 2. Shift cable assembly 3. Retainer 4. Bolt 5. Nut 6. Manual control lever ...

Shift Cable Components and components location

Components 1. Shift lever assembly 2. Shift cable assembly 3. Retainer 4. Bolt 5. Nut 6. Manual control lever 7. Knob ...

Other information:

Kia Cee'd JD Service Manual: Schematic diagrams
Circuit Diagram Input/Output Specification Connector Pin Lay Out IMS input/output pin information No Signal Name I/O Contents Remark A1 - ...

: Remote Start Settings
Switching Climate Control Auto Mode On and Off Press Settings on the touchscreen. Press Remote Start Setup. Press Climate Control. Select Vehicle. Switch Auto on or off. Note: If you switch the auto mode on, the system attempts to heat or cool the interior to 72°F (22°C). Note: When you s ...