Kia Cee'd: Manual Transaxle Control System / Shift Lever Repair procedures

Removal
1.
Disconnect the battery negative (-) cable.
2.
Remove the gear boots (A) and then remove the shift lever knob (B) by rotating counter-clockwise.

3.
Remove the floor console assembly.
(Refer to Body - " Floor Console")
4.
Remove the bracket (A).

5.
Remove the select cable (A) from the shift lever after removing the snap pin.

6.
Remove the shift cable (B) after removing the clip (A).

7.
Remove the cable sockets (A) from the shift lever.

8.
Remove the shift lever assembly (A).
Tightening torque :
8.8 ~ 13.7 N.m (0.9 ~ 1.4 kgf.m, 6.5 ~ 10.1 lb-ft

Installation
1.
Install in the reverse order of removal.
Shift Lever Components and components location
Components   1. Knob & Boots 2. Shift lever assembly 3. Shift cable 4. Select cable 5. Control cable retainer ...

Control Cable Components and components location
Components   1. Knob & Boots 2. Shift lever assembly 3. Shift cable 4. Select cable 5. Control cable retainer ...

Other information:

Kia Cee'd JD Owners Manual: Operating condition
This system will activate when the indicator on the rear parking assist OFF button is not illuminated. If you desire to deactivate the rear parking assist system, press the rear parking assist OFF button again. (The indicator on the button will illuminate.) To turn the syste ...

Kia Cee'd JD Service Manual: Fuel Pump Motor Repair procedures
Removal 1. Remove the fuel pump. (Refer to Fuel Delivery System - “Fuel Pump”) 2. Disconnect the electric pump & sender wiring connector (A). 3. Remove the fuel feed tube (A) from ...

© 2017-2025 www.kceed.com