Kia Cee'd: Lighting System / Room Lamp Repair procedures

Kia Cee'd JD Service Manual / Body Electrical System / Lighting System / Room Lamp Repair procedures

Inspection

Room Lamp

1.	Check that the switch operates properly after disconnecting the room lamp connector (A).

Removal

Room Lamp

1.	Disconnect the negative(-) battery terminal.

2.	Carefully remove the lamp lens (A) from the room lamp with a flat-tip screwdriver.

3.	Replace the bulbs (B) and remove the screws if it is necessary.

4.	Remove the room lamp assembly (A) after disconnecting the connector (B).

Vanity Lamp

1.	Disconnect the negative (-) battery terminal.

2.	Remove the vanity lamp (A) by pressing the clip with a small screwdriver.

3.	Remove the vanity lamp bulb (A) assembly after disconnecting the connector.

Installation

Room Lamp

1.	Reconnect the connector.

2.	Install the room lamp assembly.

3.	Install the lens.

Vanity Lamp

1.	Reconnect the vanity lamp connector.

2.	Install the vanity lamp.

Head Lamps Repair procedures

Inspection 1. Check-points upon head lamp failure (HID) (1) Check the battery voltage. (Low beam will be on when the battery v ...

Overhead Console Lamp Repair procedures

Inspection 1. Remove the overhead console lamp assembly then check for continuity between terminals. If the continuity is not as specified, replace the map l ...

Other information:

Kia Cee'd JD Service Manual: Assist Handle Repair procedures
Replacement • Put on gloves to protect your hands. • Use ...

Kia Cee'd JD Owners Manual: SRS components and functions
The SRS consists of the following components: 1. Driver's front air bag module 2. Passenger's front air bag module 3. Side air bag modules* 4. Curtain air bag modules* 5. Retractor pre-tensioner assemblies 6. Air bag warning light 7. SRS control module (SRSCM) 8. Front impact sensors 9. S ...