Inspection |
1. |
Disconnect the negative (-) battery terminal.
|
2. |
Remove the roof trim assembly.
(Refer to Body - "Roof Trim Assembly")
|
3. |
Disconnect the connector (A).
|
4. |
Remove the panoramaroof motor (B) after loosening 3 bolts.
|
5. |
Ground the terminals as below table, and check that the roller blind
motor operates.
|
Resetting The Panoramaroof |
1. |
Turn the ignition key to the ON position and then close the panoramaroof
completely.
|
2. |
Release the panoramaroof control lever.
|
3. |
Press and hold the CLOSE button for more than 10 seconds until the panoramaroof
has moved slightly.
|
4. |
Release the panoramaroof control lever.
|
5. |
Press and hold the CLOSE button once again within 3 seconds until the
panoramaroof do as follows;
|
6. |
Reset procedure of panorama system is finished.
|
1. |
The panoramaroof ECU detects the Run- time of motor
|
2. |
Motor can be operated continuously for the 1st run-time (120 ± 10sec.).
|
3. |
The continuous operation of motor stops after the 1st Run-time (120
± 10sec.).
|
4. |
Then Motor is not operated for the 1st Cool-time (18 ± 2sec.).
|
5. |
Motor is operated for the 2nd Run-time (10 ± 2sec.) at the continued
motor operation after 1st Cool-time (18 ± 2sec.)
|
6. |
The continuous operation of motor stops operating after the 2nd Run-time
(10 ± 2sec.)
|
7. |
Motor is not operated for the 2nd Cool-time (18 ± 2sec.).
|
8. |
Motor repeats the 2nd run-time and 2nd cool-time at the continued motor
operation.
T1 : 120 ± 10 sec., T2 : 18 ± 2 sec.,
T3 : 10 ± 2 sec., T4 : 18 ± 2 sec.
|
Kia Cee'd JD Service Manual: Troubleshooting
Troubleshooting
Problem Symptoms Table
Before replacing or repairing air conditioning components, first determine if
the malfunction is due to the refrigerant charge, air flow or compressor.
Use the table below to help you find the cause of the problem. The numb ...
Kia Cee'd JD Owners Manual: To install the barrier net
1. Open the cover (if equipped) for the
holder position (1) or (2) you want to
install.
2. Compress the one side net upper shaft
to length direction before insert the net
upper shaft into the large hole (3) and
then secure by sliding into the small
hole (4).
3. Hang the net strap ...